is a batch file-renamer (KDE).
| INSTALL (krename-4.0.9) | : | INSTALL (krename-4.90.90) |
|---|
|
| | |
| | To install KRename run the following commands: |
| | |
| | > mkdir build |
| | > cd build |
| | > cmake |
| | > make |
| | > sudo make install |
| | |
| | All common CMake options should also work for KRename. |
| | After KRename was installed, you can run a selftest using krename --test |
| | |
| | The instructions below are outdated. KRename uses CMake now! |
| | |
| Basic Installation | | Basic Installation |
| ================== | | ================== |
| | |
| These are generic installation instructions. | | These are generic installation instructions. |
| | |
| The `configure' shell script attempts to guess correct values for | | The `configure' shell script attempts to guess correct values for |
| various system-dependent variables used during compilation. It uses | | various system-dependent variables used during compilation. It uses |
| those values to create a `Makefile' in each directory of the package. | | those values to create a `Makefile' in each directory of the package. |
| It may also create one or more `.h' files containing system-dependent | | It may also create one or more `.h' files containing system-dependent |
| definitions. Finally, it creates a shell script `config.status' that | | definitions. Finally, it creates a shell script `config.status' that |
| | | |
| End of changes. 1 change blocks. |
|---|
| 0 lines changed or deleted | | 14 lines changed or added |
|---|
"Fossies" - the Fresh Open Source Software Archive 