"Fossies" - the Fresh Open Source Software archive 
Member "lm_sensors-3.3.3/prog/sensors/sensors.1" of archive lm_sensors-3.3.3.tar.gz:
Table of Contents
sensors - print sensors information
sensors
[ options ] [ chips ]
sensors -s [ chips ]
sensors --bus-list
sensors is used to show the current readings
of all sensor chips.
sensors -s is used to set all limits as specified in the configuration file.
sensors --bus-list is used to generate bus statements suitable for the configuration
file.
- -c, --config-file config-file
- Specify a configuration file. If no
file is specified, the libsensors default configuration file is used. Use
‘-c /dev/null’ to temporarily disable this default configuration file.
- -h, --help
- Print
a help text and exit.
- -s, --set
- Evaluate all ‘set’ statements in the configuration
file and exit. You must be ‘root’ to do this. If this parameter is not specified,
no ‘set’ statement is evaluated.
- -A, --no-adapter
- Do not show the adapter for each
chip.
- -u
- Raw output. This mode is only meant for debugging.
- -v, --version
- Print
the program version and exit.
- -f, --fahrenheit
- Print the temperatures in degrees
Fahrenheit instead of Celsius.
- --bus-list
- Generate bus statements suitable for
using in sensors.conf. Such bus statements are only needed if you have several
chips sharing the same address on different buses of the same type. As bus
numbers are usually not guaranteed to be stable over reboots, these statements
let you refer to each bus by its name rather than numbers.
/etc/sensors3.conf
/etc/sensors.conf The system wide configuration file. See sensors.conf(5)
for further details.
sensors.conf(5)
Frodo Looijaard and
the lm_sensors group http://www.lm-sensors.org/
Table of Contents